göldo "Vintage" Neck / ST-Shape / Finished / 7,25"göldo Vintage-Spec Neck with traditional 7.25" fretboard radius, 21 frets and medium D shaping. Finished with a thin layer of high-gloss clear lacquer. Fretted with Vintage "Spaghetti" frets (2.1mm x 1.1mm). The maple variant (one-piece) features the iconic "Skunk-Stripe" on the back. Vintage...
BLANK BODY MAHOGANY SANDED (48 X 35 X4.5 cm) Swietenia macrophylla
Fingerboard maple, 648mm scale, 22 fret slots 500mm x 65mm x 7mm (dimensions may vary slightly) Made in France
Fingerboard rosewood, 648mm scale, 22 fret slots 500mm x 65mm x 7mm (dimensions may vary slightly) Made in France
Knurled press-fit bushings for vintage tuners. Press-Fit like regular vintage bushings but with the appearance of a hex nut. Diameter at the bottom 8.8mm, at the top 10mm Inner diameter 6.4mm Height 8mm Set of 6.
Allow fitting of traditional vintage tuners into modern 10mm pegholes. Usually, vintage type tuners are being installed into 8.5mm pegholes. These adapters are for everyone who wants to fit vintage tuners into modern 10mm pegholes. Inner diameter: 6.4mm Set of 6 pcs
Allow fitting of traditional vintage tuners into modern 10mm pegholes. Usually, vintage type tuners are being installed into 8.5mm pegholes. These adapters are for everyone who wants to fit vintage tuners into modern 10mm pegholes. Inner diameter: 6.4mm Set of 6 pcs
Plain press-in bushings for vintage tuners. Diameter at the bottom 7.2mm (for 7mm holes) and 10.5mm at the collar. Inner diameter 6.4mm. Height 8mm. Set of 6.
Allow centering a tuner shaft on the backside of the headstock inside a 10mm peghole. Why you ask? If you want to install vintage tuners on a headstock with 10mm pegholes, the problem is how to center the 6.3mm shafts of the new tuners in the holes. One solution is to fill the holes and then drill new ones with the proper diameter. Or you simply use these...